Recording Vocals in Your Home: The 9 Common Big Mistakes and How to Avoid Them.

Updated: Apr 18, 2019

Let’s face it and all agree recording vocals properly is the cornerstone of a good mix.

They tell the story and set the emotional tone for your listeners. The truth is, an amazing vocal will make or break your song. Capturing your amazing vocal and guaranteeing an emotional journey takes several variables.

In this blog, you will discover the 9 common recording mistakes that can ruin any vocal and how you can avoid them.

Let’s go!

1. You chose the wrong room.

It’s easy to think that mixing has the biggest impact on the vocal. But in reality, your recording is far more important.

Your choice of room is one of the most influential factors when you are recording vocals. From personal experience recording in a home studio poses many challenges…

You probably don’t have access to a professional vocal booth. You only have access to what you have—maybe just a few rooms in your home:

  • A kitchen.

  • A bedroom.

  • A bathroom.

  • A living room.

  • And so on…

The BIGGEST mistake at this phase you can make is choosing the most convenient room in your home!

The room that an instrument is recorded in always changes the tone. This is ESPECIALLY true for vocals.

If your vocals are recorded in a bad room, it’s extremely obvious by the end of the mix.

Reverb pulls the vocals back in a mix. The more reverb an instrument has, the less it sounds present and “in your face.” It sounds farther away from the listener and the emotional component you want to convey is impossible.

You want the singer to sound up-close and personal. The room that an instrument is recorded in always changes the tone. This is ESPECIALLY true for vocals.

So… what room should you pick?

Use a small-to-medium sized room with a lot of stuff in it. Specifically, with a lot of SOFT stuff like beds, couches, pillows, rugs and so on. When I first started recording I used a closet that had all the before mentioned in droves!

All of those items tend to absorb sound, making the room less reverberant and more neutral for getting the best vocal.

You also want to avoid rooms with a lot of hard surfaces and windows. So your kitchen and bathroom are not the best places to record a vocal.

The other side of the coin is you don’t want your room to be too noise absorbent. Your vocal will sound flat and muffled if you have too much absorption.

So in other words, find a balance.

Contrary to popular belief, a closet is NOT a good room for recording vocals. That myth started because professional vocal booths tend to be small and secluded.

But the difference is that professional vocals booths are often covered in soundproofing fiberglass over 12 inches deep! Unless that’s how your closet was built, avoid it for recording vox.

Believe me, no matter how many clothes you have hanging in your closet, a closet simply does not have enough absorption material to keep the room resonances out. The reverb, though extremely short, will be extra loud in the microphone (especially once the voice is compressed).

So, think about this when you’re recording vocals. You’ll get a better sound with a well treated room!

2. Your mic placement is wrong

Once you’ve found the right room, your job isn’t over. Far from it.

The next common mistake is mic positioning errors. It may seem small, but trust me—mic position is important to the tone! I used to put my mic in the corner of the room thinking it would eliminate reverb.

Your 2 rules of thumb for mic placement are:

  • Don’t put the microphone in the exact center of the room.

  • Put the microphone as far away from the walls as possible.

This will prevent you from recording any weird room resonances that occur outside the “sweet spot.”

So where’s the sweet spot? Here’s a simple chart to show you

Stay out of the light gray area and you’re good. You don’t want to be in the center of the room, and you don’t want to be close to the sides either.

Stay in the dark gray and you’ll be fine.

Hot tip: If you can, point the mic at one of the corners of the room. This increases the distance to the closest wall.

3. Your room isn’t treated

Condenser microphones are pretty sensitive. They can pick up stray sounds from all the way across the room.

In other words treating the space around your microphone is essential!

If you have proper acoustic panels, use them to create a temporary vocal booth around the vocalist.

If you don’t have proper acoustic panels, use what you have on hand—Mattresses, duvets, and heavy curtains can work to create a makeshift booth. All of those extra covers have now found their purpose!

A great test if you are wondering if something will absorb enough sound? Try shouting at it and listen for how much sound it absorbs. The more the better.

Hot tip: If you can’t create the classic “triangle” vocal booth, then put something up behind the singer’s head. That’s the area that will affect the sound the most.

4. You’re using the wrong microphone

At this point, you’re starting to understand the main rule of recording vocals: EVERYTHING affects the tone. Each vocalist has a different tone to their voice. Some are deep and powerful, others are high and airy. There’s a thousand possibilities in between.

Match your microphone to your vocalist!

Every microphone is going to sound different.

But there are some general concepts that are important to know.

  • Small Diaphragm Condenser Mics

Small diaphragm condenser mics tend to sound bright and airy. The bass response is noticeably lower.

  • Large Diaphragm Condenser Mics

Large diaphragm condenser mics tend to sound clean and focused. The frequency response tends to be pretty balanced.

  • Dynamic Mics

Dynamic mics tend to sound warmer and more aggressive. There’s less top end, which works perfectly for certain singers and genres.

The mic you pick will depend on what you’re looking for from your vocalist.

You could be looking for a mic that will accent their natural tone. For example, if you have a bright and airy singer and you want their tone to be even more obvious, then a small diaphragm condenser mic is perfect.

Other times you might want a mic that will balance their tone. If you feel like the bright and airy tone from your vocalist is too much, then a dynamic mic might be perfect to warm things up a bit.

No matter what, make sure you experiment! Set up 2 to 3 microphones and have the vocalist sing the chorus into each of them. Listen back to the tracks and see what you think.

If you only have the budget for one microphone, I recommend the Se 2200a II. It’s an affordable condenser microphone that’s well balanced for the price. If you need to start your microphone collection somewhere, it’s a great place to start.

Hot Tip: Change the mic out if your vocalist is going to be singing harmonies! The change in tone will help the main vocal to stick out more.

5. You’re using an omnidirectional mic

Let me be clear: Omnidirectional microphones can sound awesome. Especially for intimate, whispery vocals.

But for home recording, they have a fatal flaw: They pick up EVERYTHING in the room.

While cardioid microphones (like the Se 2200a C) pick up sound from one direction, An omnidirectional mic does exactly what the name says: It picks up all sound in the room equally.

When you’re recording vocals in a professionally treated sound booth, using an omnidirectional mic is totally fine. There’s very little room sound for the microphone to pick up, so it’s irrelevant what direction it picks the sound up from.

But when you’re recording at home, in a bedroom or living room, omnidirectional mics make it nearly impossible to record a dry vocal.

So unless you have a well treated room, stay away from omnidirectional mics.

6. You’re keeping the mic at lip-level (unless that’s what sounds best)

Once you’ve found exactly which room and mic to use, you’re almost done.

You already know where to put your mic in relation the room, but where do you put it in relation to the singer?

These three placement factors can change the tone of your microphone:

1. Distance

If you’re using a condenser mic, the distance between the mic and the singer will have the greatest effect on the tone because of the proximity effect.

The proximity effect is the closer you get to the microphone, the boomier your vocals become:

  • If I was a 12 inches away, the vocal would sound open and airy.

  • If I was 5 inches away, the vocal would sound warm and intimate A good starting place is to set the singer 6 inches away from the mic, and then move them forward or backward to get the tone you’re looking for ( I prefer about 6.5 inches…yes OCD’ish but I can tell a huge difference from 5 to 7 inches).

Hot tip: Don’t put your vocalist closer than 5 inches away. Things can get too muddy real fast.

However, for dynamic mics a good place to start is 2 inches away. They are designed to be used this way. You can move forward and back from there.

2. Height

Height is another factor in the tone you get from your mic. When a mic is at lip level, it’s at your “default” height, so to say.

When you lower the microphone, you’re increasing the low end of the voice. The closer you get to the chest, the more prominent the low-end.

The opposite is true as well – when you raise the microphone, the top end is accentuated.

Make sure the vocalist looks straight ahead when singing, otherwise they’ll put unnecessary stress on their vocal chords!

3. Axis

The axis of the microphone. Pointing the microphone at the singer is standard, of course. But when you rotate the mic, you’re reducing the bass from your singer. You’re also reducing plosives. This is a great thing to try for singers with heavy P’s and S’s (I had this problem before I learned this). Try moving the mic 20 degrees to the left and right and see what sounds best. If you tweak these three variables accordingly, you should get the tone you’re looking for before you ever reach for an EQ! AWESOME!

7. Your levels are too hot

This one is easy to overlook…

When you’re setting levels, try to maintain 10dB of headroom.

Without getting into the technical details, the digital sweet spot is basically an average level of -18dBFS. That’s where most plugins are going to sound best.

When setting your levels, try to get an average of -18dBFS. You should be peaking around -10dBFS. Make sure you’re definitely not peaking higher than -6dBFS.

This keeps your levels low enough that you won’t accidentally clip (which means you’d have to re-record the part), but also avoid recording too quiet either.

8. You only recorded one take

Make su